Screen Calibration Ruler

Screens do not report their physical size, so a ruler on screen can look right and still be off. Calibration tells this site how many screen pixels equal one millimeter on your device. Use the calibration tool below, then check it against an object you know.

Needs calibration.Markings are estimates until you calibrate this screen.

0123456789101112

Needs calibration.Markings are estimates until you calibrate this screen.

Tap the ruler to set a start point.

Credit card method

  1. Open Calibrate and choose Credit card. A standard card measures 85.60 mm × 53.98 mm.
  2. Choose the long edge (85.60 mm), or the short edge (53.98 mm) on a phone too narrow for the long edge. Narrow phones start on the short edge.
  3. Place the card flat on the screen, then move the slider (or use the − and + buttons for fine steps) until the outline matches the card.
  4. Save. Saving replaces any earlier calibration for this screen.

Manual method

  1. Open Calibrate and choose Manual. The reference bar is drawn 100 mm long at the current scale.
  2. Measure the bar on screen with a physical ruler you trust, in millimeters.
  3. Enter the measured length and save. The ruler rescales to match. A result outside 2 to 20 pixels per millimeter is refused as a measuring mistake.
  4. On a phone the 100 mm bar is wider than the screen; use the card's short edge there instead.

Calibrate each device

Phones, tablets, laptops, and external monitors all differ in pixel density and scaling, so calibrate each one separately. Calibration is saved for each screen in this browser and stays when you rotate a phone or tablet. Browser zoom changes the size of everything on the page, so if you zoom in or out the ruler shows a warning and asks you to calibrate again at that zoom; your earlier calibration comes back when you return to the old zoom.

What calibration does not do

Calibration makes the scale match your screen. It cannot correct for a bent card, a reference ruler that is itself inaccurate, or a screen that is viewed at an angle. The accuracy of the result depends on the measurement you enter.

Frequently asked questions

Why is my ruler wrong after I calibrate?
Check that the card lies flat, that you matched the outline edge to edge, and that browser zoom was the same as when you calibrated. If the zoom or display scaling changed, calibrate again.
Do I need to calibrate every time?
No. Calibration is saved in this browser. Calibrate again if you clear browser data, switch browsers, or change zoom or display scaling.
Can I calibrate without a credit card?
Yes. Use the manual method with any physical ruler you trust. Measure the 100 mm reference bar and enter the length you read.
Is automatic calibration accurate?
No. Automatic mode applies a standard 96-pixel-per-inch estimate. It is not a calibration, because the physical size of your screen is not known.